开机与关机程序及调试
Turn-on and Turn-off、FROM MOLD step and adjust
一、開機:
Run:
(一)、开启电源与冷却水水源
Turn the power and cooling water ON
(二)、按本机(开机/关机)机键,可能产生如下情况:
Press the key of (RUN/STOP) will possibly:
Q:泵浦反转提示灯亮,蜂鸣器警告。
Pump reverse indicator lights up, and alarm buzzer rings.
A:关闭电源,将外部三相电源线中任意两项经对换位置,按回复即可。
Turn the power off. Exchange the place of each other of the two in the 3-phase power wire, and then connect again.
Q:缺油指示灯亮,蜂鸣器警告。
Oil-short indicator lights up and the alarm buzzer rings.
A:补充导热油。
Examine the heat-transfer oil .
Q:泵浦过载指示灯亮,蜂鸣器警告。
Pump overload indicator lights up, and the alarm buzzer rings.
A:请压下马达积热电池之回复按钮,并检查三相电源是否欠相。
Please press the reset key of the motor and check 3-phase shortage.
二、关机:
Stop:
(一)、先将温度降至60℃以下,再按(开机关机)。
First set the temperature under 60℃,then press the key of (RUN/STOP).
(二)、若长期不使用,将所有球阀打开泄放系统内之油,并关掉电源。
If nonuse for long time, turn on all the valves to leak oil then turn power off.
三、冷却关机程序:
Cooling turn off procedures:
模温机在正常工作状态或待机时→按冷却关机健→模温机强制冷却,冷却时间为15分钟→时间到→停机。
When machine running or stand by→press Cooling turn key→machine compel cooling,cooling time about 15minutes →time is up →stop.
OTP-30-24KW机型规格表
Specifications of OTP-30-24KW
机 型 MODEL | OTP-30-24KW |
温控范围 CONTROL RANGE | 进水温+35℃~300℃ |
温控方式 TEMP.CONTROL METHOD | 双组P.I.D微电脑自动演算 (PROPORTIONAL INTEGRAL DERIVATIVE) |
电 源 POWER | 3 φ 380 V 50 Hz (OR OTHER) |
传热媒体 HEAT TRANSFER MEDIUM | 导热油 HEAT TRANSFER OIL |
冷却方式 COOLING MEHTOD | 间接冷却 INDIRECT COOLING |
加热能量 HEATING CAPACITY | 24KW(12KW×2) |
泵马力 PUMP POWER | 3HP |
泵流量 MAX.PUMP FLOW | 10M3/H |
泵压力 MAX.PUMP PRESSURE | 3.1KG/CM2 |
存油量 EXPANSION TANK CAPACITY | 57 LITER |
冷却配水管 COOLING WATER PIPE | 3/4″ |
循环油配管 CIRCULATION OIL PIPE | DN32(8进8出到3/8″蝶阀) |
外型尺寸 LXWXH | 1680㎜×500㎜×1150㎜(含阀门/轮子高度) |
机 重 WEIGHT | 约150 KG |